AEC_Q100_Rev_G_Base_Document(17)

车用电子产品的执行标准。

TEST GROUP D – DIE FABRICATION RELIABILITY TESTS (CONTINUED)

# NOTES SAMPLE SIZE / LOT ADDITIONAL REQUIREMENTS NUMBER OF LOTS ACCEPT CRITERIA TEST METHOD

D3

---

STRESS

ABV

Hot Carrier Injection HCI --- --- --- ---

The data, test method, calculations and internal criteria should be available to the user upon request for new technologies.

---

internal criteria should be available to

SM

internal criteria should be available to

Component Technical Committee

TEST GROUP E – ELECTRICAL VERIFICATION TESTS

# NOTES SAMPLE SIZE / LOT NUMBER OF LOTS ACCEPT CRITERIA TEST METHOD ADDITIONAL REQUIREMENTS

STRESS

ABV

Automotive Electronics Council

Table 2: Qualification Test Methods (continued)

Page 14 of 32

E1

0 Fails H, P, B, N, G

Pre- and Post-Stress Function/Parameter All All

TEST

Test program to supplier data sheet or user specification

Test is performed as specified in the applicable stress reference and the additional requirements in Table 2 and illustrated in Figure 2. Test software used shall meet the requirements of Q100-007. All electrical testing before and after the qualification stresses are performed to the limits of the individual device specification in temperature and limit value.

Electrostatic Discharge Human Body Model / Machine Model

HBM / MM

E2

H, P, B, D

See Test Method

1

0 Fails 2KV HBM 200V MM

AEC Q100-002 Q100-003

TEST before and after ESD at room and hot temperature. At least one of these models must be performed. Device shall be classified according to the maximum withstand voltage level. Device levels <2000V HBM and/or <200V MM require specific user approval.

AEC - Q100 - REV-G

May 14, 2007

Electrostatic Discharge Charged Device Model

CDM E3

H, P, B, D

See Test Method

1

AEC Q100-011

0 Fails 750V corner pins, 500V all other pins better)

TEST before and after ESD at room and hot temperature. Device shall be classified according to the maximum withstand voltage level. Device levels <750V corner pins and/or <500V all other pins CDM require specific user approval.