电压检测MAX110ACPE[1](2)

Low-Cost, 2-Channel, ±14-Bit Serial ADCsMAX110/MAX111

ABSOLUTE MAXIMUM RATINGS

VDDto GND...........................................................................+6VVSSto GND (MAX110)..............................................+0.3V to -6VAGND to DGND.....................................................-0.3V to +0.3VVIN1+, VIN1-......................................(VDD+ 0.3V) to (VSS- 0.3V)VIN2+, VIN2-......................................(VDD+ 0.3V) to (VSS- 0.3V)VREF+, VREF-....................................(VDD+ 0.3V) to (VSS- 0.3V)Digital Inputs and Outputs.........................(VDD+ 0.3V) to -0.3VContinuous Power Dissipation

16-Pin Plastic DIP (derate 10.53mW/°C above +70°C).....842mW

16-Pin Wide SO (derate 9.52mW/°C above +70°C)......762mW20-Pin SSOP (derate 8.00mW/°C above +70°C)...........640mW16-Pin CERDIP (derate 10.00mW/°C above +70°C)......800mWOperating Temperature Ranges

MAX11_ _C_ _......................................................0°C to +70°CMAX11_ _E_ _...................................................-40°C to +85°CMAX11_BMJE.................................................-55°C to +125°CStorage Temperature Range.............................-65°C to +160°CLead Temperature (soldering, 10sec).............................+300°C

Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functionaloperation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure toabsolute maximum rating conditions for extended periods may affect device reliability.

ELECTRICAL CHARACTERISTICS—MAX110

(VDD= 5V ±5%, VSS= -5V ±5%, fXCLK= 1MHz, ÷2 mode (DV2 = 1), 81,920 CLK cycles/conv, VREF+= 1.5V, VREF-= -1.5V, TA= TMINto TMAX, unless otherwise noted. Typical values are at TA= +25°C.)

2_______________________________________________________________________________________