海上平台常用英语

308. Prepare spud plate and wireline to check water depth. 准备测深板和钢丝绳

测量水深

309. Record all pressure tests on a chart recorder. 用试压表记录试压记录 310. Visually inspect all sealing element. 目视检查所有密封件

311. Check and tighten all bolts. 检查并上紧所有螺栓

312. Bleed off surface accumulators. 地面管线排空气

313. Check for leaks. 检查有无泄漏

314. Lift BOP stack and replace wellhead connector AX ring. 吊起防喷器组并

更换连接器AX密封圈

315. Function test wellhead. 对井口头进行功能试验

316. Fill kill and choke valves with seawater. 将压井阀和阻流阀注满海水 317. Pressure test to 500psi then bleed off test pressure. 试压到500psi, 然后放

掉压力

318. Reduce hydraulic control manifold pressure to 5200 kpa. 将液压控制管线

压力减少到5200千帕

319. Switch to alternate control pod. 把闸门开关倒到控制面板

320. Guidelines are slacked off. 导向绳松了

321. Slack off drill pipe and release running tool. 放松钻杆并卸开下入工具 322. Run subsea TV to observe bit entering the TGB. 下水电视观察钻头是否进

入临时导向基板

323. Don’t rotate until hole opener passes through the TGB. 在扩眼器通过临时

导向基板前不要旋转

324. Position permanent guide base (PGB) below rotary table. 在转盘下安放永

久导向基板

325. Monitor riser level via trip tank. 用计量罐来控制隔水管内的液面 326. Pressure test to 5000psi. 试压5000psi

327. Pick up test mandril and place in BOP. 吊起试压防喷器芯子并装入防喷器

组

328.

Safety and Firefighting 安全与消防

328. Get a Work Permit before you can start the hot work. 办理作业许

可证才能进行动火作业

329. Welding is not allowed. 不准动焊

330. Put on your (safety) helmet. 戴上安全帽

331. It’s a high voltage area. 这是高压区

332. That’s against the rule. 这是违章作业

333. Don’t walk under the crane load. 不要在吊物下走动

334. The repairing is under way. 正在检修