非常好的直线电机样本

4.4

4.4.1

4.4.2 Table of ContentsInitialization__________________________________________4-11Linear motors of the LinMot® P series_______________________4-11Stepper motors_________________________________________4-13

SYS1 interface_________________________________________4-14

SYS2 connector_________________________________________4-16

COM connector_________________________________________4-17

Connection of LinMot® P linear motors______________________4-18

Connecting stepper motors________________________________4-19

Connecting inductive loads________________________________4-194.5Signal interfaces______________________________________4-144.5.14.5.24.5.34.6Actuator interfaces____________________________________4-184.6.14.6.24.6.3

4.7Connecting the power supply____________________________4-20

E100/E200/E400 supply__________________________________4-20

E1000/E2000/E4000 supply_______________________________4-21

Signal board configuration________________________________4-234.7.14.7.24.8

4.9HW configuration of the electronic units__________________4-23Mechanical installation_________________________________4-254.8.1

4.10Constructive notes on the installation of the linear motors____4-26

5.Configuration Software_________________________________5-1

5.1

5.2

5.3

5.4

5.5

5.6

5.7Installation requirements________________________________5-1Installation of the configuration software___________________5-2Introduction___________________________________________5-3Login________________________________________________5-3Commander___________________________________________5-4Control Panel_________________________________________5-4Parameter Inspector____________________________________5-5

Editing the parameters____________________________________

Saving and loading parameter sets___________________________

Copy and Paste__________________________________________

Verifying parameter settings________________________________

Printing parameter sets____________________________________

Write-protected parameters_________________________________

Online mode____________________________________________

Offline mode____________________________________________

User interface of the Curve Inspector________________________

Operational elements of the Curve Inspector__________________

Curve Editor interface____________________________________

Operational elements of the Curve Editors____________________

Creating curves with the wizards___________________________

Defining reference curves in Excel__________________________

Setting the recording variables_____________________________

Setting the trigger mode__________________________________

Determining the sample rate_______________________________

Adjusting the display____________________________________

Starting and stopping the Oscilloscope_______________________

Printing recorded curves__________________________________

5-65-75-75-85-85-95-95-95.7.15.7.25.7.35.7.45.7.55.7.65.7.75.7.85.8Curve Inspector______________________________________5-105-105-105-135-145-165-175-195-195-205-215-215-215.8.15.8.25.8.35.8.45.8.55.8.65.9Oscilloscope__________________________________________5-185.9.15.9.25.9.35.9.45.9.55.9.6