MOSEL VITELIC

Module Part Number Information

V436632S04VTG-10PC

Block Diagram

MOSEL VITELIC

Serial Presence Detect Information

A serial presence detect storage device -2

EPROM - is assembled onto the module. Informa-tion about the module configuration, speed, etc. is

V436632S04VTG-10PC

written into the E2PROM device during module pro-duction using a serial presence detect protocol (I2Csynchronous 2-wire bus)

SPD-Table:

Hex Value

ByteNumber

01234567891011121314151617181920212223242526272829

Function Described

Number of SPD bytesTotal bytes in Serial PDMemory Type

Number of Row Addresses (without BS bits)Number of Column Addresses (for x8 SDRAM)Number of DIMM BanksModule Data Width

Module Data Width (continued)Module Interface LevelsSDRAM Cycle Time at CL=3

SDRAM Access Time from Clock at CL=3Dimm Config (Error Det/Corr.)Refresh Rate/TypeSDRAM width, Primary

Error Checking SDRAM Data WidthMinimum Clock Delay from Back to BackRandom Column AddressBurst Length SupportedNumber of SDRAM BanksSDRAM DIMM Module AttributesSDRAM Device Attributes: General

Maximum Data Access Time from Clock for CL = 2 Minimum Clock Cycle Time at CL = 1

Maximum Data Access Time from Clock at CL = 1Minimum Row Precharge Time tRP

Minimum Row Active to Row Active Delay tRRDRCD

SPD Entry Value

128256SDRAM13101640LVTTL10.0 ns6.0 nsnone

Self-Refresh, 15.6µs

x8n/a / x8tccd = 1 CLK1, 2, 4, 8, full page

4CL = 2 & 3WL = 0

Non Buffered/Non Reg.

Vcc tol ± 10%10.0 ns6.0 nsNot SupportedNot Supported

20 ns16 ns20 ns

100 MHz-10PC

8008040D0A01400001A06000800800018F04060101000EA0600000141014