Low-Voltage, High-Speed, Quad, SPST

CMOS Analog Switches

ELECTRICAL CHARACTERISTICS—Single +2.5V Supply

(V+ = +2.5V, VINH= 0.7VCC, VINL= 0.5V, TA= TMINto TMAX, unless otherwise noted.) (Note 2)

Note 2:The algebraic convention, where the most negative value is a minimum and the most positive value a maximum, is used in

this data sheet.

Note 3:Guaranteed by design.

Note 4: RON= RON(max) - RON(min).

Note 5:Flatness is defined as the difference between the maximum and minimum value of on-resistance as measured over the

specified analog signal range.

Note 6:Leakage parameters are 100% tested at maximum-rated hot temperature and guaranteed by correlation at +25°C.Note 7:Off-Isolation = 20log10(VCOM_/ VNO_), VCOM_= output, VNO_= input to off switch.Note 8:Between any two switches.

_______________________________________________________________________________________5

MAX4614/MAX4615/MAX4616