Hypermesh 10.0 实例教程

Step 21: Trim a line by plane and delete a redundant line segment. 1. Go to the Line Edit panel.

2. Go to the split at plane sub-panel.

3. With the lines selector active, select the vertical line that does not have a fillet. 4. Set the orientation vector to z-axis.

5. Choose node 1 as the base node.

6. Click split to split line 4 by the X-Y plane.

7. Press the F2 key to access the delete panel.

8. Switch the entity type to lines.

Choose the small line segment under the X-Y plane, and click delete entity to remove the

9. line segment.

10. Click return twice to return to the main menu.

Step 22: Remove all temp nodes.

1. Access the temp nodes panel in one of the following ways:

From the Menu Bar, select Mesh, then Delete, then Nodes From the main menu, select the Geom page, then select temp nodes

2. Click clear all to remove all temp nodes.

3. Click return to return to the main menu.

Step 23: Change the rendering mode.

1. On the visualization toolbar, click Shaded Geometry (

The plane (purple) becomes shaded instead of wire frame. ).