大众车行车电脑说明书

Getting Started - Section 1-BStep #3 (USB Only) If you are using a Serial Interface then you can proceed to step #4. If you are using a USB Interface, a message like this should pop up: Click on the Found New Hardware message and the Found New Hardware Wizard should start up. If you are prompted with the choice, pick “No, Not This Time” when asked if you want to connect to the Internet to search for drivers. Select "Install the software automatically (Recommended)" then click [Next >] The process should be automated but you may need to click “Continue Anyway” part way through the process. If you are using Windows 98/ME then you should follow the USB Driver Installation Instructions that should automatically pop up on your screen. If, for some reason, you installed the USB Interface without following the above instructions, and VCDS does not work correctly, go into your PC’s Device Manager while the USB Interface is connected. You can find the Device Manager by right-clicking on My Computer in XP or on Computer in Vista. Select Manage to bring up Computer Management. On the left side of the screen under System Tools, select Device Manager. Find the “VCDS Compatible USB Interface” and delete it. It may be under “Other Devices” or under “Universal Serial Bus Controllers”. Next, unplug the USB Interface from your PC, wait 5 seconds and plug it back in. Proceed with the installation starting on Step 2.Step #4 Connect the car end of your Interface to your vehicle’s Diagnostic Port. If your vehicle has a 2x2 port (some pre-1996 vehicles), then use the optional 2x2 Adapter between the Interface and the ports in the car. This is included in the Pro-Kit.Turn the vehicle’s ignition switch to the ON position. Make sure the key is turned far enough that the dash lights are fully illuminated. The engine may either be running or stopped.