EN10025-5-2005(18)

EN 10025-5:2004 (E)

13) 14) 15) 16) 17) 18)

For flat products of quality J2 and K2 out of each parent plate or coil the impact properties only shall be verified (see 8.3.2.2).

For flat products of quality J2 and K2 out of each parent plate or coil the impact properties and the tensile properties shall be verified (see 8.3.2.2).

For plates and wide flats the permissible surface discontinuities and for the repair of surface defects by grinding and/or welding another class than class A, subclass 1 of EN 10163-2 applies (see 7.5.2). For sections the permissible surface discontinuities and for the repair of surface defects by grinding and/or welding another class than class C, subclass 1 of EN 10163-3 applies (see 7.5.3).

For bars and rods the permissible surface discontinuities and for the repair of surface defects by grinding and/or welding another class than class A of EN 10221 applies (see 7.5.4). Other tolerances than class A of EN 10029 for hot rolled plates apply (see 7.7.1).

19a) The delivery condition +N or +AR is required (see 6.3).

19b) The delivery condition +AR is required with a verification of the mechanical properties on normalized

samples (see 7.3.1.3). 21)

The grain size shall be verified for products of quality J2 and K2 with nominal thickness < 6 mm (see 7.3.2.3).

15